Suspension Type Chip Spreader DAS-3000

The DAS-3000 chip spreader is mainly used to spreading chips after
the asphalt spraying work for prime coat, tack coat and water-proof
coat in road construction of high level. It also can be used for the
construction work of country road with smaller traffic flow. Pls. see
figure 1 for the outline of the chip spreader.
Our DAS-3000 Chip Spreader is designed in hanging structure. It is
hanged at the back end of the dumper truck to work with the tilter to
be lift up at 35°~45°. The spreading rate can be adjusted through the
changing of gate openness and motor speed. These two methods should be
done at the same time. The spreading width and position can be managed
by opening and closing of the specified nozzles.
1.Main Technical Parameter
No. |
Item Name |
Unit |
Standard Value |
Remark |
|
Spreading Width |
mm |
3000 |
250-3000(Grade Difference:250) |
|
Spreading Speed |
km/h |
3~4.8 |
|
|
Maximum Spreading Quantity |
L/m2 |
22 |
|
|
Minimum Spreading Quantity |
L/m2 |
3 |
|
|
Chipping Size |
mm |
3~25 |
|
|
Overall Dimensions |
mm |
2700×2100×1850 |
|
|
Total Mass |
kg |
1100 |
|
2.Performance Feature
2.1. The aggregate size of available spread is large enough to meet the requirements of various aggregate spread demand.
2.2. The amount of spread is not affected by the speed of the vehicle, spread the aggregate evenly.
2.3. The speed of the screw is synchronized with the speed of the material, which is good for the feed.
3.Construction Samples
Note: All Specifications are subject to change without Notice